Pentax K-30 - Adjusting the White Balance with Color Temperature

147
Shooting Settings
5
4 Use the four-way controller (23)
to select a number, and press the
4 button.
The white balance settings of the selected
image are saved as Manual White
Balance and the camera is ready to take a
picture. The white balance setting is
K .
Use to set the color temperature value.
1 Select K in Step 2 on p.144, and press the M button.
2 Adjust the color temperature with
the front or rear e-dial.
You can set the color temperature value
within the range from 2500K to 10000K.
Color temperature steps vary depending on the e-dial.
*1 The default setting for Color Temperature step units is [Kelvin]. You can change the
step units to [Mired] in [12. Color Temperature Steps] of the [A Custom Setting 2]
menu. However, figures are converted to and displayed in Kelvin.
3 Press the 4 button.
The White Balance setting screen reappears.
4 Press the 4 button.
The camera is ready to take a picture.
Adjusting the White Balance with Color
Temperature
E-dial Kelvin Mired
*1
Front (R) 1 Step (100K) 1 Step (20M)
Rear (S) 10 Steps (1,000K) 5 Steps (100M)
Save as Manual 2
Save as Manual 2
Save as Manual 3
Save as Manual 3
Save as Manual 1
Save as Manual 1
Saves this image's White
Saves this image's White
Balance settings as a custom
Balance settings as a custom
selection
selection
100-0001
100-0001
OK
OK
OK
Cancel
Cancel
MENU
Cancel
Cancel
MENU
OK
OK
OK
±0
±0
G3
G3
A2
A2
Check
Check
10000K
10000K
e_kb524_84percent.book Page 147 Friday, June 15, 2012 12:13 PM