207
Changing Additional Settings
7
The date and time set in “Initial Setting” (p.56) serve as the date and time
of your present location. Setting the destination in [World Time] enables
you to display the local date and time on the monitor when traveling
abroad.
1
Select [World Time] in the [R Set-up 1] menu, and press the
four-way controller (5).
The [World Time] screen appears.
2
Use the four-way controller (45) to
select X (Destination) or W
(Hometown) for [Time Setting].
This setting is reflected in the date and
time that appear in the control panel.
3
Press the four-way controller (
3
) to select [
X
Destination],
and press the four-way controller (
5
).
The [X Destination] screen appears.
4
Use the four-way controller (45) to
select a destination city.
Turn the rear e-dial (S) to change the
region.
The location, time difference and current
time of the selected city appear.
5
Press the four-way controller (3) to select [DST], and use the
four-way controller (45) to select P or O.
Select O if the destination city uses daylight saving time (DST).
6
Press the 4 button.
The destination setting is saved and the screen that was displayed in
Step 2 appears again.
Setting the World Time
MENU
World Time
Time Setting
Destination
London
Hometown
New York
16:00
10:00
Destination
DST
London
Cancel
MENU
OK
OK
+06:00
16:00
e_kb524_84percent.book Page 207 Friday, June 15, 2012 12:13 PM
To Next Page
Loading...
