97
Shooting Functions
4
3
Press the 4 button.
If you select [Auto], [Low], [Medium], [High] or [Off], proceed to Step 7.
4
Use the four-way controller (23) to select [Setting], and press
the four-way controller (5).
The screen to set the noise reduction level according to the ISO
sensitivity appears.
5
Use the four-way controller (23) to
select a sensitivity value, and use
the four-way controller (45) to set
the level of noise reduction which is
applied to the selected sensitivity
value.
The sensitivity values displayed vary
according to the [1. EV Steps] and
[2. Sensitivity Steps] settings made in the [A Custom Setting 1] menu.
Available operations
6
Press the 3 button.
The screen that was displayed in Step 2 appears again.
7
Press the 3 button twice.
The camera is ready to take a picture.
Rear e-dial (S) Switches between [High-ISO NR 1] and [High-ISO
NR 2].
d button Resets the set value to the default setting.
MENU
High-ISO NR
100
200
400
800
1600
3200
6400
1 2
Reset
e_kb524_84percent.book Page 97 Friday, June 15, 2012 12:13 PM
To Next Page
Loading...
