99
3
Taking Pictures
6
Press the 3 button.
The camera returns to capture status.
Refer to the section “To Set the White Balance Manually” for
instructions on adjusting the white balance manually.
Have a blank sheet of white paper or similar material ready.
1
In the [White Balance] screen, use the four-way
controller (23) to select K (Manual).
2
Point the camera at the blank
sheet of paper or other material so
that it fills the frame displayed in
the center of the screen.
3
Press the shutter release button fully.
The white balance is automatically adjusted.
4
Press the 4 button.
The setting is saved and the [
A
Rec. Mode] menu reappears.
5
Press the 3 button.
The camera returns to capture status.
You can adjust the overall brightness of the picture.
Use this function to take pictures that are intentionally overexposed or
underexposed.
1
Press the 3 button in A mode.
The [A Rec.Mode] menu appears.
Saving the White Balance setting 1p.110
To Set the White Balance Manually
Setting the Exposure (EV Compensation)
MENU
Adjust
SHUTTER
White Balance
Cancel
OK
OKCancel
OK
To Next Page
Loading...
Need help?
General
