110
3
Taking Pictures
Saving the Settings (Memory)
The Memory function is for saving the current camera settings when the
camera is turned off.
For some camera settings, the Memory function is always set to O (On)
(the settings are saved when the camera is turned off), while for others
you can choose O or P (Off) (to choose whether the settings are saved
or not when the camera is turned off). The items which can be set to O
or P in the Memory function are shown in the table below. (Items not
listed here are always saved in the selected settings when the camera is
turned off.)
If you select O, the settings will be saved in the status they were in
immediately before the camera was turned off. If you select P, the
settings will be reset to the defaults when the camera is turned off. The
table below also shows whether the Memory default setting for each item
is O or P.
Item Description
Default
Setting
Page
Face
Detection
The Face Detection mode set with the I button. P p.67
Flash Mode The flash mode set with the four-way controller (4) O p.92
Drive Mode The drive mode set with the four-way controller (2) P
p.85
p.86
Focus Mode The focus mode set with the four-way controller (5) P p.94
Zoom Position The zoom position set with the Zoom button P p.73
White Balance
The [White Balance] setting on the [A Rec.Mode]
menu
P p.98
Sensitivity The [Sensitivity] setting on the [A Rec.Mode] menu P p.101
EV
Compensation
The [EV Compensation] setting on the
[A Rec.Mode] menu
P p.99
Digital Zoom
The [Digital Zoom] setting on the [A Rec.Mode]
menu
O p.75
DISPLAY
The information display mode set with the
4/W button
P p.20
File No.
If a new SD Memory Card is inserted when On has
been selected, file numbers are assigned sequentially.
O —
To Next Page
Loading...
Need help?
General
