Pentax Optio S1 - Changing the Start-Up Screen

177
7
Settings
You can choose the start-up screen displayed when the camera is
turned on.
You can choose any of the following images as the start-up screen:
- The Guide Display Start-up Screen showing a guide for the shooting
modes and buttons
- PENTAX logo
- One of your own images (compatible images only)
1 In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2 Use the four-way controller
(2345) to select R (Start-up
Screen).
3 Press the 4 button.
The image selection screen appears.
4 Use the four-way controller (45)
to choose the image for the start-
up screen.
Only images available for the start-up
screen are displayed. You can also choose
the PENTAX logo screen or the Guide
Display Start-up screen already stored in
the camera.
5 Press the 4 button.
The start-up screen is set.
Changing the Start-up Screen
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card is formatted.
• The start-up screen is not displayed when set to [Off].
• The start-up screen is not displayed when the camera starts up in the
playback mode.
For setting a captured
image as the Start-up
Screen
2 / 2
2/2
Start-up Screen
Start-up Screen
Start-up Screen
OK
OK
OK
MENU
Cancel
Cancel
OK
Cancel
100
1 0 0
-
0017
0 0 1 7
100
-
0017
MENU
Cancel
C a n c e l
OK
O K
Cancel
OK
OK