Pentax Optio S1 - Correcting Defective Pixels in the CCD Sensor (Pixel Mapping)

178
7
Settings
Pixel Mapping is a function for mapping out and correcting defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1 Press the 3 button in A mode, and press the four-
way controller (5).
The [W Setting] menu appears.
[Pixel Mapping] cannot be selected when the 3 button is pressed
in Q mode.
2 Use the four-way controller (23) to select [Pixel
Mapping].
3 Press the four-way controller (5).
The [Pixel Mapping] screen appears.
4 Use the four-way controller (23)
to select [Pixel Mapping].
5 Press the 4 button.
Defective pixels are mapped and corrected.
Correcting Defective Pixels in the CCD Sensor
(Pixel Mapping)
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Charge the battery
or replace it with a fully charged battery.
Setting
Pixel Mapping
Format
MENU
Exit
3/3
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel
OK
OK