Pentax SF1 - Focus Lock

FOCUS LOCK
Be careful!
If the shutter is released at this moment, the subjects
will be out of focus. The background will be in focus
instead.
If the subject is not positioned In the focus frame [[ }]
at the center of the viewfinder, use the focus lock by
following the procedures described at right. The focus
lock can be used only in the AF SINGLE mode.
1. Position the subject in the focus frame at the center
of the viewfinder and press the shutter release button
halfway down. The green in-focus signal [Oj and the
PCV tone confirm that the subject is in focus.
2. While you hold the shutter release button halfway
down, recompose the image to your liking and release
the shutter.
• As long as you hold the shutter release button halfway
down and the green in-focus signal is on, the focus
remains locked. When you remove your fmger, it is
unlocked. This procedure can be repeated any number of
times.
• 32