Pepperl+Fuchs IC-KP-B17-AIDA1 - Page 86

2014-02
86
IC-KP-B17-AIDA1
Commands
To write the special read only code use the commands SP and EP; to read it out, use the
commands SS and ES.
If SP or EP is used to write to an IDC-...-1K tag, the tag is then locked. If you wish to write to the
tag again using standard commands, unlock it using the command SI.
single read special fixcode (SS)
Command:
Response:
The R/W head makes only one attempt to read a special read only code.
Byte Contents Bit no.
7 6 5 4 3 2 1 0
Byte 0
1)
Telegram length, high byte 0 0 0 0 0 0 0 0
Byte 1
1)
Telegram length, low byte 0 0 0 0 1 0 1 0
Byte 2 Command code (0Ah) 0 0 0 0 1 0 1 0
Byte 3 FixLen/Ident channel/Toggle bit <FixLen> <Channel> <T>
1)
This byte is only used with the TCP/IP and MODBUS TCP/IP protocol.
Byte Contents Bit no.
7 6 5 4 3 2 1 0
Byte 0
1)
Telegram length, high byte 0 0 0 0 0 0 0 0
Byte 1
1)
Telegram length, low byte 0 0 0 0 1 1 0 0
Byte 2 Command code (0Ah) 0 0 0 0 1 0 1 0
Byte 3 Reserved/Ident channel/Toggle
bit
- - - - <Channel> <T>
Byte 4 Statu s <Status>
Byte 5 Reply counter <ReplyCounter>
Byte 6
2)
ID code 00h ... FFh <IDCode>
... ID code 00h ... FFh <IDCode>
Byte N
3)
ID code 00h ... FFh <IDCode>
1)
This byte is only used with the TCP/IP and MODBUS TCP/IP protocol.
2)
The first byte indicates whether an EPC code is shown
■ 1 = EPC application
■ 0 = 18000-6C (ISO)
3)
N = <FixLen> + 5; Ethernet/IP: N = <FixLen> + 3