36
Chapter 9: Cleaning and Disinfection
IPV®-2C and Stand
Percussionaire® Digital Multimeter (PDM)
Clean the IPV®-2C and stand according to hospital/institutional protocols. Always clean
between patients and when visibly soiled. Clean the controller and stand with a clean,
lint-free cloth or paper towel moistened with the cleaner.
CAUTION: Do not spray any cleaning solution directly on the IPV®-2C or stand.
CAUTION: Do not immerse or allow liquids to access the controller.
CAUTION: Use only approved cleaners.
Clean the PDM when visibly soiled or according to facility protocols.
Do not spray any type of cleaner directly onto the multimeter. Clean the glass with
a product or chemical approved for cleaning glass only.
CAUTION: Use of cleaning methods not outlined in these instructions may cause
damage to the multimeter.
WARNING: The cell used in this device may present a risk of re or chemical
burn hazard if mistreated. Do not recharge, disassemble, heat above 100°C (212°F) or
incinerate. Replace cell with type recognized CR123A only, or Percussionaire®
part PRT-B13350. Use of another cell may present a risk of re or explosion.
Dispose of in accordance with appropriate regulations, country, local
and state laws.
Phasitron®5 Breathing Circuit
Follow hospital/institutional guidelines for cleaning or storage between treatments. It
is not necessary to clean the Phasitron®5 after each use; however, rinsing with sterile
water is advised. When disassembling the Phasitron®5, visually inspect the exterior of
all parts, including tubing, for corrosion, discoloration, pitting, and missing O-rings.
CAUTION: Do NOT immerse the antibacterial lter of the tubing harness.
To Next Page
Loading...
