14
2.5 Batteries for Camera
Set the shutter release mode selector lever to L (to turn the power o).
Use six AA alkaline or rechargeable batteries.
NiCd or NiMH batteries should only be used in the camera body if CF04 is
set on rechargeable.
1. Lift the battery case lock lever, turn it counter clockwise and pull out the
battery holder.
2. Insert fresh batteries with the + and - ends as shown in the
illustration.
3. Return the battery holder to its case and lock it by turning the lever
clockwise. Make sure it is rmly attached.
- Ensure that the batteries are placed with proper polarity.
Checking the Battery Power
Set the Drive dial lever to S (to turn the power on).
Check the battery condition in the lower left corner of the top LCD screen.
Always use six new batteries of the same type when replacing batteries. Do
not mix dierent types of batteries or use old batteries with new ones. The
camera will not function without a power source.
Never throw out batteries. When a battery does not work, deliver the
battery for appropriate disposal.
The batteries are suciently charged.
There is little power remaining. Have new
batteries on hand. Camera will still operate.
There is very little power remaining. Camera
will not operate. Set the shutter release mode
selector lever to “L” (to turn the power o) and
replace the batteries with new ones.
When the batteries are emptied for power,
“batt” ashes on the main LCD and the
viewnder’s LCD when the shutter release
button is pressed.
To Next Page
Loading...
Need help?
General
