PhaseOne 645DF - 3.11 Flash Compensation Settings

44
3.11 Flash Compensation Settings
By combining a Metz ash and the SCA3952 adapter, the camera adjusts for
ash. It can be adjusted within ±3EV in increments of 1/3 steps.
1. Turn on the Power
Install the SCA3952 adapter on the Metz ash, and attach it to the camera.
Lock the ash in place using the locking knob on the ash shoe. Turn the
shutter release mode selector lever to the S or C position, and turn ON the
ash power switch.
2. When the ash charge conrmation lamp lights, press the set button [A] .
The icon is displayed on the main LCD panel.
3. Turn the front or rear dial to select the ash compensation value.
External LCD Panel (normal display)
4. When the shutter button is half-pressed, the display appears on the
external LCD, and appears on the LCD inside the viewnder with a +
compensation, or appears with a – compensation.
Viewnder LCD Readouts
- If the ash-charge mark is not displayed, the ash compensation button [A]
cannot be used.
- Keep pressing the set button to activate the ash compensation mode. You
can check the exposure compensation value.
- If you turn the shutter release mode selector lever to the L (power OFF)
position, the compensation value will be cancelled.
P
Av
Tv
M
X
CF
C1
C2
C3
A
P
Av
Tv
M
X
CF
C1
C2
C3
 

