Philips 4000 - Page 18

PHILIPS 4000 and 3000 03 BRIEF INSTRUCTIONS
2/13
The machine is warming up.
The brew group is being reset
due to machine reset.
Fill the coffee bean hopper.
The brew group must be
inserted into the machine.
Empty the coff ee grounds
drawer. Wait 5 seconds before
reinserting it.
Fill the water tank.
Fill the coffee bean hopper with
coffee beans and restart the
cycle.
The machine is priming the
circuit.
The machine is performing the
rinse cycle. Wait until the machine
has completed the cycle.
Completely insert the drip tray
with the coffee grounds drawer
into the machine and close the
service door.
The machine needs the
“INTENZA+”waterltertobe
replaced.
The machine is programming
the amount of milk to be
dispensed for a cappuccino.
The machine reminds you to
insert the carafe and remove
the dispensing spout.
The machine is programming
the amount of coffee to be
brewed for a cappuccino.
The machine is programming
the amount of milk to be
dispensed for frothed milk.
Warning Signals (Yellow Colour)
Warning Signals (Red Colour)
Insert the water dispensing spout and press the “ ” button to start dispensing.
Press “ ” to exit.
You need to descale the machine. Press the “ ” button to start the descaling
process. Follow the steps described in the “Descaling” chapter of this manual.
Ifyouwanttodescalethemachinelater,pressthe“”buttontocontinueusing
the machine. Please note that not descaling your machine will ultimately make it
stopworkingproperly.Inthiscase,repairisNOTcoveredunderyourwarranty.