Philips 4000 - Machine Performance Parameters and Descaling

PHILIPS 4000 and 3000 02 TECHNICAL SPECIFICATIONS
5/5
2.3. Machine parameters and performance
PRODUCT
QUANTITY
Default quantity
(Grams)
User
programmable
Programm. by
Production /
Service
Espresso 40 +/- 10gr Yes No
Espresso lungo 120+/-10% Yes No
Classic coffee Min.145 Max.190 Yes No
Hot water Continues until the water supply has been exhausted (capacitive sensor)
Steam
pannarello
(frother)
Continues until the water supply has been exhausted (capacitive sensor)
Descaling cycle frequency
Hard-
ness
Water hardness Withoutwaterlter Withwaterlter
1 Soft (up to 7°dH) 240litres(480,000pulses) 480litres(960,000pulses)
2 Medium (7° - 14°dH) 120litres(240,000pulses) 240litres(480,000pulses)
3 Hard (15° - 21°dH) 60litres(120,000pulses) 120litres(240,000pulses)
4 Very hard (over 21°dH) 30litres(60,000pulses) 60litres(120,000pulses)
The default water hardness level is 4. Each litre of water corresponds to approximately
2,000pulses.
In the machines where is not possible change the water hardness the default
hardness level is 3.
WATER TANK Description
Waterreserve(pulses)withwaterlter 200
Waterreserve(pulses)withnowaterlter 200
WaterreservemodiablebyProduction/Service
departments
No
"Filltank"alarm Yes
"No tray" alarm Yes (Fill tank)
Water mains No
DREG DRAWER Description and values
Time-out for dreg drawer
5 sec.
Reset dreg counter
Dregemptyingalarm,ifthedregdraweris
removed for more than 5 seconds.
STANDBY Description and values
Inlet time (default) 15 minutes
Inlet time programmed by Production/Serv-
ice
Yes
Boiler temperature during Standby Boiler OFF