Philips 4000 - Steamout

PHILIPS 4000 and 3000 05 SERVICE MODE
17/18
5.2.1. SteamOut
To enter in SteamOut
The machine enters SteamOut mode by holding pressed together the COFFEE button and the
CALC_CLEAN button while switching on the machine.
Once entered the machine shows LedDescaleandLedRinsingashinginseries.
If there is a failure on NTC (Ntc disconnected or in short circuit) the operation cannot be per-
formed and the LEDGeneralAlarmwillblink (turn off the machine and repair before do
Steam-out operation).
If Door is opened or drag drawer is removed LED WASTE FULL will be switched on. To start
again the
operation insert drag drawer and close service door.
At the end of procedure LED ESPRESSO and LED COFFEE turns on.
When the Steam-Out is complete the following parameters are resetted to their default values:
•LengthEspressoproduct
•LengthCoffeeproduct
•Stand-ByTime
•CountCoffee(Groundcounter)
•TherequestforPrimingtheCircuitattherstswitchonisset.
•Aroma
•AromaImpulses
•FilterPresence
•FilterPulses
•Dynamicthreshold
•HistoryofgrindingsforBeansPresencedetection