Philips 4000 - Gear Motor Disassembly and Replacement

PHILIPS 4000 and 3000 07 DISASSEMBLY
6/9
The following are located inside the compartment protected
by the casing:
- Electric motor (A) with gears (B) and (C) for transmission
and timing of the dispenser.
- Brewing unit present microswitch (E).
- Microswitch (D) detecting brewing unit home and work posi-
tions.
- Remove the gear (C) that meshes with the motor transmis-
sion shaft.
- Remove the large gear (B).
-Removethemotor(A),completewithtransmissionshaft.
Replacethegear(B),makingsurethattheimprintof
the arrow is aligned with the opening containing the
pin (P).
When replacing the motor and the transmission
shaft,makesuretheguiderunners(L)areinthe
right position.
Grease the shaft thoroughly and evenly.
E
A
B
C
D
B
P
H
L
7.8. Gear motor
Loosen the screws as illustrated and
remove the gear motor cover.