Philips 4000 - Page 22

PHILIPS 4000 and 3000 03 BRIEF INSTRUCTIONS
6/13
The machine is warming up.
The machine is performing the
rinse cycle. Wait until the machine
has completed the cycle.
The brew group is being
reset due to machine reset.
Prime the circuit.
Fill the coffee bean hopper with
coffee beans and restart the
cycle.
The machine needs the
“INTENZA+”waterltertobe
replaced.
Warning Signals (Yellow Colour)
You need to descale the machine. Press the “ ” button to start the descaling
process. Follow the steps described in the “Descaling” chapter of this manual.
Ifyouwanttodescalethemachinelater,pressthe“”buttontocontinue
using the machine.
Please note that not descaling your machine will ultimately make it stop
workingproperly.Inthiscase,repairisNOTcoveredunderyourwarranty.
Completely insert the drip
tray with the coffee grounds
drawer into the machine
and close the service door.
Fill the coffee bean hopper.
The brew group must be
inserted into the machine.
Empty the coffee grounds
drawer. Wait 5 seconds before
reinserting it.
The machine is out of order. The error code is displayed in the right bottom
corner.Forerrorcodes1-3-4-5,pleaserefertothe“Troubleshooting”chapter.
Foranyothererrorcodes,followtheinstructionsbelow:
Turn off the machine. Turn it back on after 30 seconds. Try this 2 or 3 times.
Fill the water tank.
Set the “ESPRESSO” or “COFFEE”
selection lever to “COFFEE” within
30 seconds to complete brewing.
Set the “ESPRESSO” or “COFFEE”
selection lever to “ESPRESSO”
within 30 seconds to complete
brewing.
Warning Signals (Red Colour)
Exx