Setting the time/date automatically
This function uses the information sent via the local PBS channel to automatically set the
time/date. For this reason, you must enter the PBS channel that sends this additional information
When the DVD Recorder chooses a wrong PBS channel or the displayed time/date is wrong,
you must manually set the date/time (see section 'Manually setting the time & date').
3
4
5
6
7
Press SYSTEM-MENU on the remote control. The menu bar
will appear
Select 'T_' using 41 or • ,
Select line 'Installation' using CH-• or CH+ • and confirm
with •
Select line 'Time/Date' using CH-• or CH+ • and confirm
with •
Select 'Automatic' with CH- • or CH+ • and confirm with
Select the corresponding line with CH- • or CH+ • .
Select the channel which sends the time/date information in the
line 'PBS Channel' and confirm with OK. The DVD Recorder
will check whether or not the information transfer is possible.
x 'Clock not set, check channeF will appear on the TV screen
v_ No time/date data can be received from this TV channel.
Select a different channel or 'Auto: in line 'PBS Charmer. Problem
8
9
Select one of the following settings in line 'Daylight Saving':
'On': The time set corresponds to summer time (summer time
activated)
'Off: The time set corresponds to the winter time (summer time
is off)
In the line 'Time Zone', select your time zone if the PBS channel
entered was for a different time zone. This is the only way to set
the time correctly, or, if necessary, to correct it.
If you want to use the time zone of the PBS channel, select
'Auto.'
0 Confirm the changes with OK.
1 To end, press SYSTEM-MENU
The time and date are automatically transferred from the selected 'PBS channel' after the
Recorder is shut off.
Time/Date
Automatic
PBS Channel Auto.
Daylight Saving Off
Time Zone Auto.
To exit press
SYSTEMMENU
28 Installing your DVD recorder
To Next Page
Loading...
Need help?
General
