5
Confirm with OK.
xThe following message appears on the screen: 'Please enter
channel numbed
¢_ The channel number of the TV channel has not yet been assigned to
the PlusCode number. Ushlg • , _ or the number buttons 0..g on
the remote control, select the corresponding channel number (name)
of the TV channel and confirm with OK,
xThe following message appears on the screen: 'PlusCode
number wrong'
¢_ The entered PlusCode number is incorrect. Repeat your entry or
cancel using the SYSTEM-MENU button,
¢_ Check the time/date (see 'Setting the time & date' in 'lnstalIing your
DVD recorder').
x The following message appears on the screen: 'Date does not
match Mon-Fr_
¢_ A daily recording was entered for the wrong day, Daily programming
can only be used for recordings to be made from Monday to Friday,
Problem
6
7
8
9
10
The decoded data appears _fter confirmation. You can go back
and change the data Select the appropriate input field with • or
4 . Change the information with <I , • or the number buttons
0..9,
Change 'AM/PM'
Use the SELECT button to select 'AM or 'P/t_ in the input fields
'Star_ and 'End.
Changing the recording mode
Select 'RecMode' using • .
Using CH-V , select the recording mode 'M1, M2, M2x, M3, M4, M_.
If all information is correct, press the OK button The
information is stored in a TIMER block.
To end, press TIMER.
Insert a recordable disc in the Recorder.
The disc is checked.
Switch the Recorder off with STANDBY (_,
The programmed recording will only function properly when the
DVD Recorder has been switched off using the
STANDBY © button.
Tip
Tfmer
VCR Plus+ system
Rec
Date Ch. Start End Mode
01/22 001 08:3rAM 10:00PM M1
To store
Press OK
If any of the TIMER blocks are in use, 'TIMER' will light up on the display
Programming a recording (TIMER) 61
To Next Page
Loading...
