Philips ErgoLine D320 - Endgerät Auswal Ziffer (EAZ); Adjusting the EAZ for D320

ErgoLine D310/320
Customer Engineer Manual
Page 5-8
•
the D310 emits two beeps within 5 seconds. It is now operational
the D320 displays the date and time ( or **-**-** if the date/time is not set in the
switch) within 10 seconds. It is now operational.
Endgerät Auswahl Ziffer (EAZ)
Terminals must have an “equipment end dialling code” (Endgerät Auswahl Ziffer)
for identification . The EAZ is used to determine:
•
which incoming calls, presented on the interface by the PABX, will be
accepted by the terminal in question
•
which terminal identification will be supplied for the PABX during outgoing call
set up. The PABX will determine the directory number with the aid of the EAZ.
Adjusting the EAZ for D320:
The two settings EAZ-1 and EAZ-2 are programmed as follows:
1 place the handset on hook
2 press PROGRAM key
3 press “9”
4 press PROGRAM key
5 EAZ-1and EAZ-2 are displayed:
6 enter a character to change the setting for EAZ-1. This character can be a
digit,
0
to
9
, or
*
.
As soon as the first digit, EAZ-1, is entered the second digit, EAZ-2, is cleared.
7 press PROGRAM key to select this setting when EAZ-2 does not need to be
defined
8 if EAZ-2 is to be defined, enter the required character. This character can be
a digit,
0
to
9
, or
*
9 press PROGRAM to store the new settings.
The default setting is:
EAZ-1
*
and EAZ-2
-
.
When EAZ-2 is not specified (-), the default setting is the value of EAZ-1
EAZ-1 EAZ-2 Outgoing call set up is
made with:
(See remarks)
Terminal accepts incoming
calls with:
‘0’-‘9’ ‘-‘ EAZ-1: ‘0’-‘9’ EAZ-1: ‘0’-‘9’
‘0’-‘9’ ‘0’-‘9’ EAZ-1: ‘0’-‘9’ EAZ-1: ‘0’-‘9’ or EAZ-2 ‘0’-‘9’
‘0’-‘9’ ‘*’ EAZ-1: ‘0’-‘9’ All incoming calls are
accepted
‘*’ don’t
care
‘0’ All incoming calls are
accepted
T
ABLE
5.2: EAZ
ADJUSTMENT FOR
D320