Philips Pathology Scanner SG20 - Page 99

Glass slides, cover slips and markers Technical data
99
4522 207 12671 * 2021-06-17
Pathology Scanner SG20 / SG60 / SG300
Definition Specification
Sides and finish types • 90 degrees (long and short sides) with either a 'cut' or 'ground'
finish side
• 90 degrees 'cut' finish, with 45 degree beveled 'ground' edges
(long sides)
• 45 degrees (long and short sides) with a 'ground' finish
Note:
- A 'cut' finish looks shiny and transparent. The side is similar to a
side of shattered glass.
- A 'ground' finish looks matte. A cut side has been grinded, obtain-
ing the matte ground finish.
Corners
Corner types • 90 degrees corners (flat, unmodified corners)
• 45 degrees bevelled corners of max. 3 mm along each side
Note: Glass slide corners are either unaltered (90 degree) or have a
'ground' finish, which looks matte.
Sides and corners damages
Side damages Nicks at the sides:
• at most 0.5 mm in length and depth along the short sides
• at most 1.0 mm in length and 0.5 mm in depth along the long
sides
• up to 10 nicks in total
Corner damages Chipped corners:
• at most 1.0 mm in length and 0.5 mm in depth
Barcode area / Slide label area
Glass slide printed Frosted
Slide label Natural
Tab. 38: Glass slide specification
Definition Specification
Length 18 – 60 mm
Width 18 – 25 mm
Thickness 0.13 - 0.25 mm
Material • Glass
• Transparent cover slip tape
Tab. 39: Cover slip specification
NOTICE
The cover slip must not exceed the glass slide at all sides.