onlinecomponents.com
The Inline Controller under PC WorX
7805_en_02 PHOENIX CONTACT 3-1
3 The Inline Controller under PC WorX
3.1 Software version
Using the Inline Controller requires the following PC WorX/PC WorX Express version or later:
ILC 130 ETH PC WorX Version 5.20 Service Pack 3 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 3)
PC WorX Express Version 5.20 Service Pack 3 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 3)
ILC 150 ETH PC WorX Version 5.10 Service Pack 1 or later
(part of the AUTOMATIONWORX Software Suite 2007 1.30 Service Pack 1)
PC WorX Express Version 5.20 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40)
ILC 155 ETH PC WorX Version 5.20 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40)
PC WorX Express Version 5.20 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40)
ILC 170 ETH 2TX PC WorX Version 5.20 Service Pack 2 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 2)
PC WorX Express Version 5.20 Service Pack 2 or later
(part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 2)
For information about installing and using PC WorX/PC WorX Express, please refer to the
corresponding Quick Start Guide. This can be downloaded at www.phoenixcontact.com
and is supplied with the software.
To Next Page
Loading...
