Phoenix Contact ILC 170 ETH 2TX - Hardware and Software Requirements

onlinecomponents.com
Preface
7805_en_02 PHOENIX CONTACT 1-1
1Preface
1.1 Purpose of this manual
This manual helps you to start up and operate an ILC130ETH, ILC150ETH, ILC155ETH
or ILC 170 ETH 2TX Inline Controller.
1.2 Hardware and software requirements
Hardware/software Description
Inline Controller ILC 130 ETH ILC 150 ETH ILC 155 ETH ILC 170 ETH 2TX
Parameterization
memory, plug-in
No No No 256 MB, SD card
Ethernet cable Ethernet cable for connecting the Inline Controller to a PC
Connecting cable Connecting cable for connecting the Inline Controller to a PC (V.24 (RS-232)
cable, optional)
Automation software
PC WorX Version 5.20
Service Pack 3 or
later ****
Version 5.10
Service Pack 1 or
later *
Version 5.20 or
later **
Version 5.20
Service Pack 2 or
later ***
PC WorX Express Version 5.20
Service Pack 3 or
later ****
Version 5.20 or
later **
Version 5.20 or
later **
Version 5.20
Service Pack 2 or
later ***
* Part of the AUTOMATIONWORX Software Suite 2007 1.30 Service Pack 1
** Part of the AUTOMATIONWORX Software Suite 2008 1.40
*** Part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 2
**** Part of the AUTOMATIONWORX Software Suite 2008 1.40 Service Pack 3
For the ordering data for hardware, software, and additional documentation, please refer
to "Technical data and ordering data" on page 5-1.