Phoenix Contact ILC 170 ETH 2TX - Preface

onlinecomponents.com
7805_en_02 PHOENIX CONTACT i
Table of Contents
1 Preface ....................................................................................................................................1-1
1.1 Purpose of this manual .......................................................................................1-1
1.2 Hardware and software requirements.................................................................1-1
2 Description of the Inline Controller ...........................................................................................2-1
2.1 General description of the Inline Controller.........................................................2-1
2.2 Possible fields of application of the Inline Controller...........................................2-2
2.2.1 ILC 130 ETH .......................................................................................2-2
2.2.2 ILC 150 ETH, ILC 155 ETH, and ILC 170 ETH 2TX ............................2-3
2.3 Notes on using the Inline Controller (ILC 150 ETH/ILC 155 ETH)
in potentially explosive areas..............................................................................2-4
2.4 Unpacking the Inline Controller...........................................................................2-5
2.5 Connection and operating elements...................................................................2-6
2.6 Diagnostic and status indicators.........................................................................2-8
2.7 Mode selector switch........................................................................................2-10
2.8 Reset button (concealed) .................................................................................2-11
2.9 Parameterization memory.................................................................................2-11
2.10 Internal basic circuit diagram............................................................................2-13
2.11 Mounting and removing the Inline Controller ....................................................2-14
2.12 Communication paths.......................................................................................2-17
2.12.1 Ethernet ............................................................................................2-18
2.12.2 Serial PRG interface (Mini-DIN female connector) ............................2-19
2.13 Serial PRG interface .........................................................................................2-20
2.13.1 Function blocks for devices connected to PRG .................................2-20
2.13.2 RS232_INIT ......................................................................................2-21
2.13.3 RS232_RECEIVE .............................................................................2-24
2.13.4 RS232_SEND ...................................................................................2-26
2.13.5 Error codes of the STATUS output ....................................................2-27
2.14 INTERBUS .............................................................................................. 2-28
2.14.1 Local bus ..........................................................................................2-28
2.14.2 Remote bus ......................................................................................2-28
2.15 Power supply....................................................................................................2-29
2.15.1 Sizing of the power supply ................................................................2-29
2.15.2 Power supply connection ..................................................................2-30
2.15.3 24 V segment supply/24 V main supply ............................................2-32
2.15.4 24 V segment supply ........................................................................2-32
2.15.5 24 V main voltage .............................................................................2-32
2.15.6 24 V ILC supply .................................................................................2-33
2.15.7 Jumpers ............................................................................................2-33
2.16 Digital inputs and outputs .................................................................................2-34