© PSI (Photon Systems Instruments), spol. s r. o.
5
1 WARNINGS AND SAFETY PRECAUTIONS
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE TURNING THE PHOTOBIOREACTOR ON:
• Remove all packaging and transport protectors before connecting the Photobioreactor to the power supply.
• Use only cables supplied by the manufacturer.
• Keep the device dry outside and avoid working in high humidity environment!
• The manufacturer is not responsible for any damage due to improper operation!
• Water and other liquids should only be placed in vessels designed for the purpose and according to instructions
included in this manual.
GENERAL ELECTRICAL SAFETY GUIDELINES:
• Perform a routine check of the devices and their wiring.
• Replace worn or damaged cords immediately.
• Use appropriate electrical extension cords/power bars and do not overload them.
• Place the device on a flat and firm surface. Keep away from wet floors and counters.
• Avoid touching the device, socket outlets or switches if your hands are wet.
• Do not perform any alterations to the electrical parts of the device or its components.
The following table presents basic highlight symbols used in this manual:
To Next Page
Loading...