© PSI (Photon Systems Instruments), spol. s r. o.
14
3.2 STANDARD COMPONENTS
Photobioreactor FMT150 can be purchased in different configurations from minimal up to complex system consisting of
numerous accessories linked together. They can be controlled via the Photobioreactor control unit itself or by the PBR
software for full operation of the system. However, the Photobioreactor control unit offers only static manual control.
Minimal required configuration that is recommended to be purchased for optimal operation of the Photobioreactor
cultivation and monitoring system consists of set of standard photobioreactor components (as listed below) plus air pump
with bubble interruption valve and pH/temperature module. Components that are part of minimal Photobioreactor
FMT150 configuration are shown in Fig. 6. Optional components that are available as accessory modules and can be
purchased together with Photobioreactor FMT150 are described in chapter 5.
Photobioreactor FMT150 purchased in minimal configuration can be effectively used for cultivation and monitoring
purposes, however without purchasing PBR software no measured data can be stored and visualized as well as no user-
defined protocols can be designed. Chapter 3.3 and chapter 7.1 describe how to operate the PBR FMT150 in cultivation
mode via front panel control unit, without use of PBR software.
Note: Customers are kindly asked to check the contents of the delivered package and compare it with enclosed package
list generated based on customer‘s order. Please contact the support@psi.cz if any discrepancies occur.
As shown on Fig. 6 on page 16 the FMT150 is shipped with:
1. Power supply with the power cord.
2. Photobioreactor with integrated double-modulation fluorometer- Ft, Fm, QY and integrated optical density
measurement.
3. Cultivation vessel with capacity 400 ml (with holder) for FMT150/400, 1000 ml for FMT150/1000 or 3000 ml for
FMT150/3000.
4. LED panel shield.
5. Spare Part Kit* – for the complete list of Spare Part Kit see Tab. 4 on page 15 and corresponding Fig. 5.
6. User guide (this document) and Software manual.
7. Bubble Humidifier – To maintain stable culture volume.
Components #8 and #9 below are highly recommended for proper functionality of the PBR, but are not included in the
standard configuration and have to be purchased separately.
8. Bubble interruption valve with air pump (air pump not shown on Fig. 6).
9. pH/temperature module.
To Next Page
Loading...