rent value, if no changes were made) -
the minutes value «mm» now starts
flashing;
•
press the SET button briefly and re-
peatedly to set the correct minutes val-
ue; press and hold the SET button to
cycle the minutes value rapidly;
•
press the SET twice in succession
briefly to confirm the set value (or cur-
rent value, if no changes were made).
If the SET button is not pressed for a period ex-
ceeding 5 seconds at any time during this proce-
dure, the system exits clock setting mode.
WARNING
FOR SAFETY REASONS THE TIME SETTING IS ONLY
POSSIBLE WITH THE VEHICLE AT A STANDSTILL.
WARNING
DISCONNECTING THE BATTERY CABLES WILL RESULT
IN A RESET OF THE CLOCK
ASR SYSTEM
The ASR system is a driving aid that assists the
driver in acceleration manoeuvres, particularly on
low-grip surfaces or under conditions that can
cause sudden back-wheel slippage. The ASR in
these situations automatically intervenes by re-
ducing engine output within the limit imposed by
the grip conditions, contributing significantly to the
maintenance of stability the vehicle.
WARNING
THE ASR SYSTEM IS BASED ON THE RECOGNITION OF
SPEED DIFFERENCES BETWEEN FRONT AND REAR
WHEEL. FOR THE SYSTEM TO PERFORM CORRECTLY IN
ALL CONDITIONS,
THE PROCEDURE MUST BE PER-
FORMED EACH TIME A TYRE IS REPLACED EVEN IF ON-
LY ONE OF THE TYRES IS REPLACED.
FOR THE CALIBRATION OF THE ASR SYSTEM PERFORM
THE PROCEDURE BELOW.
WARNING
Pre-delivery Beverly 400 E5
PRE DE - 12
To Next Page
Loading...
