8. If the procedure has been completed cor-
rectly, the next time the starter switch is turned
to the "ON" position, the "ASR" icon lights up
with 1Hz slow flashing (1 flash per second).
When starting the engine, the "ASR" icon turns off
and the ASR system will be ACTIVE.
9. If the procedure is NOT completed correctly,
the "ASR OFF" icon will be switched on steady.
By pressing the appropriate button, the user can
manually reactivate the ASR system by returning
it to the previously stored calibration.
WARNING
N.B.
BY TURNING THE STARTER SWITCH TO THE "ON" POSITION, THE FLASHING ASR ICON IN-
DICATES THE SYSTEM DIAGNOSIS PHASE. IF THERE IS NO FLASHING WHEN THE ENGINE IS
STARTED, THE ASR SYSTEM MAY NOT BE WORKING.
WARNING
THE ASR SYSTEM IS ACTIVATED EVERY TIME, THE STARTER SWITCH IS TURNED TO THE
"ON" POSITION.
IF DISABLED BY THE USER, THE ASR SYSTEM KEEPS THE STATE OF INACTIVITY ONLY IF
THE VEHICLE IS OFF, BY USING THE ENGINE STOP SWITCH; THE NEXT TIME THE STARTER
SWITCH IS TURNED, THE ASR SYSTEM IS AUTOMATICALLY ENABLED.
CAUTION
IT IS RECOMMENDED TO PAY PARTICULAR ATTENTION IN THE EVENT OF ACCELERATION
FROM STANDSTILL IN CONDITIONS OF LOW GRIP, ESPECIALLY IN THE FIRST METRES.
CAUTION
A POOR STATE OF MAINTENANCE OF THE TYRES CAN RESULT IN ABNORMAL OPERATION
OF THE ASR SYSTEM.
IN CASE OF REPEATED INTERVENTIONS OF THE ASR, EVEN ON ROAD SURFACES WITH
GOOD GRIP OR SMALL THROTTLE OPENINGS, IT IS NECESSARY TO CHECK FOR WEAR AND/
OR THE STATE OF INFLATION OF TYRES FIRST.
CAUTION
IT IS EMPHASISED THAT THE RIDING AUXILIARY SYSTEM CANNOT CHANGE THE PHYSICAL
LIMITS OF GRIP AND IS NOT A SUBSTITUTE FOR PROPER MANAGEMENT OF POWER, BOTH
ON STRAIGHT STRETCHES AND IN TURNS. THEREFORE, IT IS RECOMMENDED TO ALWAYS
USE THE VEHICLE WITH THE UTMOST CARE AND IN ACCORDANCE WITH THE REGULATIONS
IN FORCE.
Beverly 400 E5 Pre-delivery
PRE DE - 15
To Next Page
Loading...
