PIAGGIO Beverly 400 E5 - Page 14

Manual calibration procedure of the ASR sys-
tem.
In order to maintain the efficiency of the ASR sys-
tem when one or both tires are replaced, a cali-
bration procedure of the ASR system must be
performed as follows on a straight flat stretch of
road:
1. With vehicle at a standstill and engine off.
2. Pull the brake lever, turn the starter switch to
"ON" and start the engine.
3. Disconnect the ASR system by pressing the
corresponding button for at least 1 second with the
engine running; The "ASR OFF" icon will be-
come steady on, initially it was off as the ASR
system had already been calibrated in the past.
4. Drive at a low speed for a few meters, until the
"ABS" indicator light stops flashing.
5. To start the programming procedure, press the
start button and the ASR button at the same time
for at least 4 seconds, until the "ASR OFF" icon
starts flashing; then release the buttons.
6. Start driving and increase the speed up to 30
km/h within 1 minute, keep the speed constant
for at least 10 seconds,
The "ASR OFF" icon switched off indicates that
the calibration was successful.
7. Stop the vehicle and shut off the engine by
turning the starter switch to the "OFF" position.
Pre-delivery Beverly 400 E5
PRE DE - 14