3. Start procedure in Self-diagnosis > Keyless
remote controls programming using PADS::
3.1 With ignition key on "ON",
3.2 Access the Keyless control unit self-diagno-
sis,
3.3 Eliminate any faults stored in the "MEM" sta-
tus, and/or proceed with the resolution of any
anomaly,
3.4 Access the "Adjustments" section and start
Adjustment> Remote Control Programming fol-
lowing the guided procedure proposed by PADS,
3.5 At the end of each remote control program-
ming, PADS shows a message "Programming
successful"; with subsequent message for request
of programming a new remote control, up to a
maximum of 4 remote controls (***),
(***) The Keyless control unit gives 5 seconds
between programming one remote control and
the other.
End of remote controls programming procedure.
Beverly 400 E5 Electrical system
ELE SYS - 81
To Next Page
Loading...
