•
Remove the holding spring and move
the petrol feed pipe to carburettor;
•
Remove the starter cover, undo the
carburettor fastening screw and re-
move the pipe.
•
Remove the lower screws fastening
the rear shock absorbers to the engine
crankcase and the supporting arm;
•
Cut the clamp on the transmission
crankcase duct; after that, disconnect
the pipe connected to the air intake on
the chassis.
•
Remove the screw supporting the ac-
celerator cable.
Runner 125 - 200 Engine from vehicle
ENG VE - 121
To Next Page
Loading...
