Removing the front wheel
Refitting the front wheel
•
Check that the seal of the relative con-
tact track on the wheel of the odometer
transmission is in good condition.
•
Insert the wheel axle, after greasing it,
from the side of the clamp on the fork
leg and also insert the transmission it-
self.
•
-Tighten the wheel axle nut to the pre-
scribed torque.
•
Tighten the safety screws of the pro-
tection.
Locking torques (N*m)
Wheel axle nut 45 ÷ 50 Safety screw on fork leg
6 ÷ 7
Handlebar
Removal
•
Remove the three handlebar covers as
explained in the Bodywork Chapter.
•
Remove the handlebar wiring fixing
clips and disconnect the electric con-
nectors from the brake levers.
•
Unscrew the fittings, then remove the
front and rear brake pump piping.
•
Remove the flexible transmission of
the accelerator and remove the throt-
tle.
•
Loosen the clamp fixing the handlebar
to the steering tube operating on the
blot, and remove the handlebar pulling
Suspensions Runner 125 - 200
SUSP - 222
To Next Page
Loading...
