PIAGGIO Runner 125 - Shock absorbers

Length of the swinging arm tube on the frame
side:
283 ± 0.1 mm
- Lubricate roller casings and the plastic bushings
with grease
- Insert the spacers
- Assemble the two arms with the relative bolt in
the position shown in the photograph
- Adjust the bolt as shown in the photograph
- Position the frame side swinging arm with the
most protruding part pointing towards the silent
block side as shown in the photograph
Recommended products
AGIP GREASE PV2 Grease for the steering
bearings, pin seats and swinging arm
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2 of the swinging arm
Refitting
- To refit, perform the removal operations in reverse.
- Grease the bearings and the rolling parts with the recommended grease.
-Complete the fitting by tightening the nuts on the relative bolts to the proper tightening torque.
Locking torques (N*m)
Engine and vehicle side swinging arm junction bolt 33 ÷ 41 Nm Swinging arm pin - Engine 64 -
72 Body shell - Swinging arm pin 76 ÷ 83 Screw fixing the silent-block support plate to the
body 42 ÷ 52
Shock absorbers
Removal
Remove the full muffler assembly.
- Remove the air filter
- Remove the upper fixing nuts to the chassis, that
can be reached from the tool compartment
- Remove the fixing bolts to the crankcase and
then the shock absorber
- Remove the fixing nut on the right and then re-
move the shock absorber
Suspensions Runner 125 - 200
SUSP - 236