PIAGGIO Runner 125 - Removing the rear wheel; Swing-arm

Removing the rear wheel
Removal
- Remove the whole muffler;
- Remove the shock absorber - wheel supporting
bracket;
- Remove the 5 screws fixing the wheel and re-
move it;
Reassembly
Carry out the previous operations in reverse order.
Locking torques (N*m)
Rear wheel axle 104 ÷ 126 Rear wheel fixing
screws 33÷37
Swing-arm
Removal
- Place the vehicle on its centre stand;
- Keep the vehicle firm;
- Remove the bolt fixing the swinging arm to the
chassis;
- Remove the central lower cover;
- Remove the three fixing screws of the bracket
supporting the buffer to the chassis, remove the
Seeger ring and then the bracket;
- Remove the spring fixing the swinging arm to the
chassis shown in the photo;
- Remove the bolt retaining the swinging arm to the
engine, and then remove the swinging arm;
Runner 125 - 200 Suspensions
SUSP - 231