This section is devoted to operations that can be carried out on the suspension.
Front
Removing the front wheel
•
Remove the front brake calliper after
undoing the screws fixing it to the leg.
•
Loosen the wheel axle locking nut.
•
Loosen the two wheel axis safety
screws on the leg on the RHS.
•
Remove the wheel axle.
Front wheel hub overhaul
- Remove the front wheel
- Keep the wheel level by means of two wooden
wedges
- With the appropriate pliers and tool remove the
wheel bearing on the side the rpm indicator detects
movement, as shown in the photograph
Specific tooling
001467Y014 Pliers to extract ø 15-mm bearings
001467Y009 Driver for OD 42-mm bearings
Suspensions Runner 125 - 200
SUSP - 220
To Next Page
Loading...
