Pilz PNOZ m B1 - Commissioning Function Test

Commissioning
Operating Manual PNOZ m B1
1003790-EN-02
| 32
Display Example Description
Use default
Change IP address
Ethernet
Use default
\..
Use program
Load default settings
IP address: 169.254.60.1
Subnet mask: 255.255.0.0
Gateway: 0.0.0.0
-> Hold down multifunction switch for
2 s in order to perform the action
6.7.2.8 Time menu
Display Example Description
Time
Show date and time
Time
Date 2014-01-31
Time 23:59:00
Show system's date and time
Set time
Set date and time
Time
Date 2014-01-31
Time 23:59:00
Time
Set time
Time set
Date 2014-01-31
Time 23:59:00
01
\..
Change date and time
-> Hold down multifunction switch for
2 s in order to access change mode
6.7.2.9 System mode menu
Display Example Description
Stop system
Restart system
System mode
\..
STOP system
Restart system
Stop system
Restart system
-> Hold down multifunction switch for
4 s in order to perform the actions
6.8 Function test during commissioning
CAUTION!
It is essential to check that the safety devices operate correctly
– After exchanging the USB memory
– After activating a project
– When the project was reset and reloaded from the USB memory fol-
lowing a restart (Reset Project menu).