Pilz PSS Series User Manual

Technical Details
10-2 Operating Manual: PSS SB 3006-3 Series
Battery
Service life
SafetyBUS p
Application range
Status indicator
Transmission rate
Cable runs
Transmission type
Connection
Integral on-board inputs
Number of inputs
Galvanic isolation
Potential isolation
Polarity protection
Connection type
Status indicator
High signal level (“1”)
Low signal level (“0”)
Input current
Input delay
Pulse suppression
Dedicated test pulse outputs
Number
Output current at signal level “1”
Lithium, Type CR2477N (see accessories)
ca. 2 years
Failsafe applications conforming to
EN 954-1, 03/97, DIN V 19250, 05/94
VDE 0116, 09/97
LED
Max. 500 kBit/s
Max. 3500 m
Differential two-wire cable,
Fibre-optic cable via fibre-optic coupler
Male 9-pin D-Sub connector
6
No
No
Yes
Screw connector
LED
+15 ... +30 VDC
-3 ... +5 VDC
Typ. 6 mA
< 1 ms
≤ 300 µs
(requirement: in the PSS Configurator, ≥ 3
ms must be configured under “Max. delay of
digital inputs” and/or “DI test time”.)
2
0.5 A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Pilz PSS Series Specifications

General

Category	Safety Equipment
Manufacturer	Pilz
Safety Standards	EN ISO 13849-1, IEC 61508, IEC 62061
Series	PSS
Safety Integrity Level	SIL 3
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Operating Voltage	24 V DC
Operating Temperature	0°C to +55°C (typical), others depending on model
Storage Temperature	-20°C to +70°C (typical), others depending on model
Protection Class	IP20
Application	Industrial safety applications