PIMA Alarm Systems Ltd.
When the countdown ends, the ARMED LED illuminates, the beeps stop, the message
“System Armed” is displayed for a few seconds and then the date and time are displayed.
2.1.1 Arming with the Master code
Master code
2.1.2 Arming with Short code or authorized User code
Short code or authorized User code
2.1.3 Single keystroke arming
Single keystroke arming is a feature that must be enabled by the installer.
It allows you to arm the system with a single long keystroke, without having to enter any
code.
Disarming, on the other hand, always requires to enter a valid code.
The single keystroke options are:
Full Arming:
Arming to “„Home 1” mode:
Arming to “Home 2” mode:
2.2 Arming with open zones
Zones cannot be bypassed during the arming procedure, i.e., they must be bypassed prior
to arming. See section 4 for details.
When trying to arm with open zones (other than delayed zones), the keypad sounds beeps
and the message “Open Zone! Press END” is displayed with the open zones („Front door‟ in
the next example), in 2 alternating screens:
To cancel the arming:
If you do not press [END], the panel will indeed be armed, but alarms will be generated
from the open zones immediately after the exit delay ends.
To Next Page
Loading...
Need help?
General