Using the SMS-100 or the GSM-200 modules, you can receive text messages on alarms
and faults, instead of synthesized voice messages.
Set here which of the dialer numbers will receive text messages.
To enable (or disable; toggle mode) a number set it to „+‟: .
or to move the cursor.
In the following example, telephone #2 receives text messages
To receive a report on arming and disarming of the system, see section 9.7.
7.3 Dialer test
Master code
When you finish to program the telephone number, you need to test them.
In the Dialer test menu, press a number between 1 and 4 (in correspondence with the
telephone numbers) and the dialer calls that number.
If a call is not received, check the programmed number; if it is correct, call a
service technician.
To Next Page
Loading...
Need help?
General