PIMA Alarm Systems Ltd.
1. INTRODUCTION
Congratulations on your purchase of the Hunter-Pro Series intruder alarm system. Much care
has been taken in developing the series. The system with its advanced features will
professionally help you to protect your premises or business.
The Hunter-Pro Series has numerous features that allow it to befit your individual needs, and
yet remain easy to program and use. It is important to read this guide thoroughly in order to
familiarize yourself with the system and take full advantage of its features. To assure optimal
safety and security, you should perform a system test at least once a week (see instructions on
section 10).
For any further questions, please contact your local PIMA distributor.
Up to date literature is available to download from our website at: www.pima-alarms.com
1.1 Safety instructions
Your Hunter-Pro Series alarm system has been registered in accordance with EN60950 and its rules. EN
60950 requires us to advise you the following information:
1. In this alarm system exist hazards of fire and electric shock. To reduce the risk of fire or electric
shock, do not expose this alarm system to rain or moisture. Pay attention: Telephone cords
could be a good conductor for lightings energy.
2. Do not open the door of the alarm system. Dangerous high voltages are present inside of the
enclosure. Refer servicing to qualified personnel only.
3. This alarm system should be used with AC 230V50Hz, protected by anti electric shock breaker.
To prevent electric shocks and fire hazards, do NOT use any other power source.
4. Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the unit,
immediately consult a qualified service.
5. Install this product in a protected location where no one can trip over any line or power cord.
Protect cords from damage or abrasion.
6. Disconnect all sources of power supply before proceeding with the installation. Pay attention:
do not install low voltage wires near AC power wires; they should be separated.
7. Connect the AC transformer output to the terminal block on the control panel as marked.
8. Connect the AC line cord to line power terminals as marked. (GND; N; L)
1.2 Main Features
Hybrid system with 8 to 32/96/144 hardwired or wireless zones (depending on your model);
Fast arming functions;
Partitioned system. See the next section
Arming options:
Full, for interior and perimeter;
“Home 1/Home 2”, for arming of some zone while others are not;
Passive, for auto-arming after a preset silence (no movement) time;
Automatic, at a preset time by day of the week;
You cannot arm the system unless all the zones are closed or were previously programmed
to be bypassed;
The system can be remote controlled via a Touch-tone telephone;
To Next Page
Loading...
Need help?
General