Pima 896 - Remote Control via Touch-Tone Phone; Basic Remote Control

Hunter-Pro Series - User Guide
27
PIMA Alarm Systems Ltd.
12.1 Basic remote control
 To remotely control the system:
1. Dial the number to which the system is connected, or answer a call from the system.
2. Wait until the system sounds 2 beeps.
The system does not except any command, before sounding the
confirmation tone sequence. It is absolutely important to wait until
the confirmation sequence is over ,before pressing any telephone key.
3. Enter the Master code or an authorized
3
User code and wait for a continuous
confirmation tone.
4. The system will now report its status by one of the following tones:
 Continuous: the system is disarmed;
 Beep: the system is armed.
 Execute a command by pressing a telephone key, as described in the next table. Every
command should be confirmed by 2 beeps:

Command
0
Silence the external siren and terminate the dialer
1
Fully arm the system
2
Disarm the system (must be enabled by the installer)
4
Arm the system to “Home 1” mode
5
Activate the on board RELAY
6
Deactivate the on board RELAY
7
Arm the system to “Home 2” mode
8
Listen-in for one minute (using MIC-200). Press again and
again to extend the listen-in in one minute
1. As a confirmation, the system sounds 2 beeps after every command.
2. While the panel is communicating, the message “Other keypad in use” is
displayed in all the keypads.
3. The system disconnects the call, after not receiving any command for 60
seconds. It then remains in standby mode for another 60 seconds (with the
above message displayed in the keypads), before returning to normal mode.
4. During listen-in, all other remote control commands are disabled.
12.2 Full Remote Control
 Follow steps 1 - 3 in the previous Basic mode section, to establish communication with
the panel.
 To activate an output:  [*]  press a number;
 To deactivate an output:  [#]  press a number.
3
In the “User settings”. See section 9.7.