Pioneer PDP-433CMX

162
Integrator Mode
12) Setting FULL MASK
This function uses the PDP internal signal to display the entire screen as one color: red, white, green or blue.
For settings other than FULL MASK: OFF, external input signals cannot be displayed.
It is an emergency measure for handling screen burn-in (although it cannot completely eliminate it).
For details, see 5.8, “Regarding the problem of images become burnt onto the screen.”
Factory preset : OFF
1 Enter integrator mode.
(See 5.4.1, “About the integrator mode.”)
The set ID will be displayed on the upper right where the
“– –“ mark is.
Select OPTION.
2 Move the cursor to FULL MASK and use the SET button to
change the setting.
Each time the SET button is pressed, the setting will change
as follows: OFF = WHITE = RED = GREEN = BLUE = ···
After setting the color for the full mask, press the MENU
button and leave integrator mode. This will display the full
mask.
FULL MASK applies to all inputs (INPUT1~5).
(NOTE) During display of the OFF TIMER mask, FULL
MASK does not operate. (However, settings can
be changed.)
Screen 1
Screen 2
]
]
O
D:
:
:
:
:
:
:
:
:
AA
S D
E
M
T
T
B
O
U
R
NO
FF
OFF
OF/F
OFF
OFF
ON
E
R
LUAKSF
S
L
E
I
DI
M
AKSM
OEDM
OEDM
OEDMOEDM
AKSMLOT
E
N
TO
R
I
O
BRR
C
ENSE
R
I
C
V
OLO
R
48 B 00
128
/ 1
1
28 128 /
1
0 / 0 .W/
PS
INPUT1
––
INTEGRATOR MENU
CHANGE EXITMENU SET SELECT
PICTURE WHITE BAL SCREEN SET UP OPTION
O
D:
:
:
:
:
:
:
:
:
AA
S
D
E
M
T
T
B
O
U
R
FFO
FF
OFF
OF/F
OFF
OFF
ON
E
R
LUAKSF
S
L
E
I
DI
M
AKSM
OEDM
OEDM
OEDMOEDM
AKSMLOT
E
N
TO
R
I
O
BRR
C
ENSE
R
I
C
V
OLO
R
48 B 00
128
/ 1
1
28 128 /
1
0 / 0 .W/
PS
INPUT1
––
INTEGRATOR MENU
CHANGE EXITMENU SET SELECT
PICTURE WHITE BAL SCREEN SET UP OPTION