169
Integrator Mode
20) Assigning a name to the monitor
The plasma display can have a 12 digit alphanumeric name assigned. This naming capability was designed to facilitate
easier management, control and accounting of multiple plasma display. Using the GET commands can retrieve the
assigned alphanumeric name and other operational information (RS-232C Adjustment Mode, page 180).
Only one name can be assigned per monitor, however each input can also have a custom alphanumeric name
assigned.
Factory preset :
&&&PLASMA&&&
1 Enter integrator mode.
(See 5.4.1, “About the integrator mode.”)
The set ID will be displayed on the upper right where the
“– –“ mark is.
Select MONITOR NAME under OPTION.
2 Move the cursor to the first character and press the SET
button. (Repeat this process to select all 12 characters.)
• Any of the 52 characters displayed on the menu screen
can be used.
• When you select a character and then press the SET
button, the input point will advance one character.
• If you make a mistake, select BACK SPACE and press
the SET button. This will move the input point back one
character.
• To restore the display to the initial setting (PLASMA),
select RESET and press the SET button.
After you have finished inputting characters, move the cursor
to END and press the SET button.
MONITOR NAME applies to all inputs.
Screen 1
Screen 2
]
]
:O FFOEDMROMRRI
OTLROCFNAN
AEMNOTMINOR AMPSAL
INPUT1
––
INTEGRATOR MENU
ENTER EXITMENU
SET
SELECT
T
H
:
:
0
CH
H
EPERATUREM
OUR METER
000 0
I:
:
––DNOSET.
AOTU:
PICTURE WHITE BAL SCREEN SET UP OPTION
INPUT1INTEGRATOR MENU
––
SET EXITMENU
SET
SELECT
MON I T OR N AME
MH
–
PO
WV
E
EEE
PAASML
CLAG
FI
QR
R
B
BACK SPACE
D
D
S
PECASS
KK
YXZUT
T
N
N
2198345
,.
760
/"
?#
() ~&:@'
To Next Page
Loading...
Need help?
General