USER MANUAL Page
28
of
92
3.3 Storage and use of the environment
The followings are the environmental conditions for the storage and use of the
device:
Storage Temperature: 0~35℃ (With packaging)
Operating Temperature: 10~30℃
Storage humidity: ＜80% (With packaging)
Use ambient humidity: 30%~75%
Air pressure for use and transportation: 800~106hPa
Avoid direct sunlight, rain is strictly prohibited
Well ventilated
Avoid storing in strong electromagnetic environment
Avoid severe vibration
Avoid storing in explosive, corrosive gases, excessive dust or salt of the
environment.
The battery may be stored within an environmental range of -10℃ to 45℃ for short
term storage.
Should the battery need to be stored for an extended period of time (over 3-months),
provide battery with a full charge and the environmental condition shall be 23±5℃
and 65±20% RH.
Battery shall be charged every three-months when in long term storage. Please
charge the battery with standard charging current for approximately 0.5 to 1-hour to
maintain 40-60% state of charge.
The rechargeable battery might lose its loading capacity and no longer
be rechargeable if a charge is not maintained.
3.4 Laser Beam Delivery
The laser beam from the S3 is delivered by a flexible quartz fiber or a fiber optic cable.
The device accepts a fiber with single core of 200μm to 400μm in diameter and
with SMA905 connectors. The fiber cable should not be bent to a radius of less than
50mm or to an angle less than 90 degrees to prevent damage. A fiber holder is
To Next Page
Loading...
Need help?
General