USER MANUAL Page
52
of
92
7 OPERATION PROCEDURE
The S3 medical diode laser is not supplied in sterilized condition. The main
unit must be disinfected and applicable components disinfected or sterilized
before use. Reference Disinfection and Maintenance sections of this
manual.
7.1 Preparations
Make sure the following tasks are completed before you start the laser device:
All personnel (users, patients and others present) have worn laser safety
goggles;
The power line of the equipment is connected to a grounded outlet of the
external power supply;
The laser hand piece is firmly connected to the device;
The Interlock is well connected.
7.2 System boot
1）Turn on the power supply of the system, the power indicator lights up, the
system fan runs, and the LCD screen lights up;
Note
There are two output modes: continuous and pulse in the S3 medical diode
laser. The operator should choose a suitable protocol according to the
patient's condition and treatment.
If the control device, regulator or is not used or operated according to the
prescribed method, dangerous radiation will be produced, which will cause
injury and damage to people and equipment. Among them, the control
devices and regulators include: LCD display, emergency stop switch, key
switch, Interlock, foot switch, etc.
To Next Page
Loading...
Need help?
General