USER MANUAL Page
35
of
92
C. Pack the foot switch, the power cable, and all other accessories in their pouches
into appropriate spaces inside the carton.
4.5 Power Description
S3 has two power supply modes: external power supply adapter and internal lithium
battery. The S3 needs to be at least 20 cm away from the wall and other objects to
ensure smooth ventilation and facilitate power switch operation. Press the power
switch to the ON position to start the device.
External power supply: Directly insert the provided adapter plug into the DC jack on
the left panel of the device. Plug the other plug of the adapter into a grounded mains
network to prevent electrical shock.
Adapter parameters:
Input: 100~240VAC，50/60Hz
Output: 18VDC, 5.55A
Internal lithium battery power supply: When using lithium battery, directly dial the
power switch to the ON position.
Battery capacity: 3500mAh.
DO NOT allow the fiber to be twisted or bent to a radius less than 50mm or
bent to an angle less than 90 degrees.
To avoid the risk of electric shock, this product shall only be connected to a
supply mains with a protective earth.
WARNING
Remove the battery if the device is not likely to be used for some time.
Note
When connecting to external power supply, only use the provided external
power to supply.
To Next Page
Loading...
Need help?
General