Safety information
l To avoid personal injury or damage to the equipment, familiarize yourself with proper procedures
and methods before you install, operate, or repair the system.
l Follow these safety precautions whenever you use your meter.
l Use the equipment only for its intended purpose.
l Always follow the specific occupational safety and health standards prescribed for your workplace.
l Place the meter close to an easily accessible wall outlet. DO NOT use a wall outlet controlled by a
wall switch or one that is shared with other equipment.
l Be certain the area in front of the wall receptacle into which the meter is plugged is free from
obstruction.
l Place the system in an accessible location to allow for proper venting of the equipment and to
facilitate servicing.
l Use the AC power cord included with the meter.
l Plug the AC power cord directly into a wall outlet located near the equipment and easily
accessible.
l The AC power cord is the primary means to disconnect this device from the AC power supply.
l DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure
there is no strain on the power cord.
l Always unplug the system and discharge static electricity before using aerosol dusters.
l Use only Pitney Bowes-approved supplies, in particular aerosol dusters. Improper storage and
use of aerosol dusters or flammable aerosol dusters can cause an explosive-like condition that
could result in personal injury, property damage, or both. Never use aerosol dusters labeled
flammable and always read instructions and safety precautions on the duster label.
l If the unit becomes damaged, unplug is from the wall.
l Keep fingers, long hair, jewelry and loose clothing away from moving parts at all times.
l Always follow specific occupational safety and health standards for your workplace.
l DO NOT remove covers. The covers enclose hazardous parts that should only be accessed by
properly trained service personnel.
l DO NOT run the system with the top cover open. Running the system with the top cover open
increases the risk of entanglement with moving parts.
l DO NOT place lighted candles, cigarettes, cigars, etc., on the system.
l Contact your system supplier for
o
Supplies
o
Material Safety Data Sheets
o
If you damage the unit
l The device is not intended for use in the immediate field of vision at the workstation. To avoid
disturbing reflections at the workstation, this product must not be placed in the immediate field of
view.
Safety
Pitney Bowes User Guide January 2021 29
To Next Page
Loading...
