ATLAS 30 of 44 User’s Manual
11.9. Configuration >> Upgrades
The “Configuration >> Upgrades” page displays the current versions of the iPM Firmware (see Figure 11.9-1),
UIM Firmware (see Figure 11.9-2), and Webserver Firmware (see Figure 11.9-3).
The iPM Firmware and UIM Firmware each have two (2) “banks” for holding up to two (2) versions of
firmware. The currently loaded iPM firmware version is found in the Slot ID rows under firmware. When a
new firmware version is uploaded to the UIM to be sent to the iPM's, that version will be displayed in the Bank
1 or Bank 2 rows under firmware..
The iPM Firmware can be upgraded by (1) selecting a firmware file and uploading it into a bank using the
appropriate “Upload Into Bank” button, (2) selecting the “Bank #” with the desired “Firmware”, (3) selecting the
“Slot ID” numbers for the iPMs that you would like upgrade, and (4) pressing the “Upgrade” button.
Figure 11.9-1: iPM Firmware Section of the Configuration >> Upgrades Page
The UIM controllers current version of firmware is displayed in the blue box labeled UIM firmware vX.XX. The
UIM code version that has been uploaded into the bank or banks will be displayed in the Bank 1 or Bank 2
rows under the Firmware column. The UIM Firmware can be upgraded by (1) selecting a firmware file and
uploading it into a bank using the appropriate “Upload Into Bank” button, (2) selecting the “Bank #” with the
desired “Firmware”, and (3) pressing the “Upgrade and reboot” button.
Figure 11.9-2: UIM Firmware Section of the Configuration >> Upgrades Page
To Next Page
Loading...
Need help?
General