Pixsys ATR620 - Programming the Starting Set-Point

63
26.1.1 Programming of starting set-point (if configured)
Press Display Do
3
Red display shows
16
or , then
(see configuration of
visualization Par.19, 4
th
digit).
Green display shows the
“starting setpoint”.
Otherwise go to point 5.
At any time press
to quit the programming
mode and save
modified data..
4
Increase/decrease value on
green display.
Enter starting setpoint
(ex. Temperature at
cycle start)
16
The first two digits indicate number of step. Last digit shows entering the
time value/duration of step or entering setpoint value (ex.:temperature value
to reach within the programmed time)