Pixsys ATR620 - Page 25

76
4
th
Digit – Cycles available to the operator
0
No cycles available
Remote setpoint enabled
1…9
1..8 cycles available for the operator
Select 9 for 15 cycles / 20 steps each
P-02
Configuration analog input AN1
Select type of thermocouple or RTD connected to input AN1,
visualization range and process corresponding to this input.
1
st
Digit – Type of sensor
0
Not used
1
Thermocouple or RTD (selected on 2
nd
digit)
2
nd
Digit – Type of thermocouple/RTD
0
Type K (-250/1350°C)
1
Type S (-50/1750°C)
2
Type T (-250/400°C)
3
Type R (-50/1750°C)
4
Type J (-200/1000°C)
5
Type E (-250/1000°C)
6
PT100 (-100/600°C)
7
NI100 (-60/180°C)
3
rd
Digit – Decimal point
0
No decimal point
1
Visualization with decimal point
4
th
Digit – Select corresponding process
0
Process 1
1
Process 2
P-03
Configuration of analog input AN2
Select type of thermocouple or signal V/mA connected to input
AN2, visualization range and process corresponding to this input
1
st
Digit – Type of sensor
0
Not used
1
Thermocouple (selected on 2
nd
digit)
2
Tension 0-1V
3
Tension 0-10V
4
Current 0-20mA
5
Current 4-20mA
2
nd
Digit – Type thermocouple/RTD
0
Type K (-250/1350°C)
1
Type S (-50/1750°C)